ING-MMA4008 Inverter MMA Welding machine

The INGCO ING-MMA4008 is an industrial three-phase inverter stick (MMA) welder for heavy fabrication and long, high-current welding. It delivers 20–400 A and runs 1.6–6.0 mm electrodes.

What it is good for

• Heavy steel fabrication: structural steel, beams, columns and heavy plate
• Tanks, heavy machinery and equipment repair
• Production welding with large electrodes and long arc times

Electrodes and materials

• Takes 1.6–6.0 mm electrodes.
• Typical current for general-purpose E6013 electrodes: 2.5 mm ≈ 60–90 A · 3.2 mm ≈ 90–130 A · 4.0 mm ≈ 120–170 A · 5.0 mm ≈ 170–240 A. Exact ranges vary by brand and type — always use the range printed on the electrode packet.
• Mild and low-alloy steel — with general-purpose rutile electrodes (E6013) or low-hydrogen electrodes (E7018) for structural and load-bearing joints
• Stainless steel — with stainless electrodes (e.g. E308L)
• Cast iron repairs — with nickel cast-iron electrodes
• Aluminium and very thin sheet (below about 1.5 mm) are better done with TIG or MIG welding

Key specifications

• Output current: 20–400 A
• Duty cycle: 400A@60%
• No-load voltage: 75 V
• Electrode diameter: 1.6–6.0 mm

Duty cycle in practice

Duty cycle 400A@60%: measured over a 10-minute period, this means about 6 minutes of welding at 400 A, followed by about 4 minutes of cooling. At lower currents the machine can weld for longer. Staying within the duty cycle protects the machine and extends its life.

Power supply

Three-phase 380–400 V, 50/60 Hz industrial supply — not a household socket. Have it connected by a qualified electrician with suitably rated cable and protection. If run from a generator, it must be a three-phase generator of adequate capacity.

Features

• IGBT inverter technology — lighter and more energy-efficient than a traditional transformer welder, with a stable DC arc

In the box (per INGCO)

• Machine only — no accessories included

You will also need

• Welding electrodes
• Welding cables, electrode holder and earth clamp — rated for the current you will use
• Welding helmet
• Welding gloves and protective clothing

Always weld with a proper welding helmet, gloves and protective clothing, in a well-ventilated area.

Specifications are as published by INGCO for model ING-MMA4008. Usage guidance reflects general welding practice — always follow the machine's manual and the electrode or wire manufacturer's recommendations.